/   /   /   /  CH - 400

Manual Lathe

CH - 400

High Speed Precision Lathe Series CH-400x800 CH-400x1100
  • Bed is made of meehanite and is hardened and precisely ground, Hardness is HS 70 degree.
  • Automatic and manual forced Lubrication pump supplies oil to cross slide and bedways.
  • Oil distributor may be adjusted to lubricate bedway, cross slide, or both.
  • Starting lever with safety device.
  • Emergency foot-operated braking system.
Capacity
Swing over bed 406 mm
Swing over carriage 238 mm
Swing over gap 580 mm
Width of gap in front of face plate 150 mm
Distance between centers ( A1 - 6, A2 - 6 ) 767, 1067mm (A1-6)
Distance between centers ( A1 - 8, A2 - 8 )
Width of bed 300 mm
Stroke of tool post 145 mm
Stroke of cross slide 265 mm
Headstock
Spindle bore 51 mm
Taper of spindle bore & center MT6xMT4
Number of spindle speeds A1 - 6, D1 - 6
Spindle nose 8
Spindle speed ( 60 HZ ) 70, 110, 180, 290, 430, 690, 1125, 1800 rpm
Threading & Feeds
Number of feeds 36
Range of longitudinal feeds metric 0.07 ~ 0.50 mm / rev
Range of cross feeds Half of longitudinal feeds
Leadscrew diameter 35 mm
Leadscrew pitch 4 TPI , P = 6 mm
Range of inch pitches 4 ~ 42 TPI ( 36 Kinds )
Range of metric pitches 0.4 ~ 7.0 mm ( 36 Kinds )
Tailstock
Quill stroke 170 mm
Quill diameter 60 mm
Quill taper MT # 4
Motor
Main motor ( 30 min. ) 5 HP ( 7.5 HP ) *
Coolant pump motor 1 / 8 HP
Machine dimension
Height 1400 mm
Floor space 2000, 2300 × 1000 mm
Weight 1450, 1550 kgs
  • Specifications are subject to change without notice.
Standard equipment & accessories
  • Leveling screws
  • Service kits & Tool box
  • 9" backplate
  • Main motor 5HP / 4P
  • Coolant system
  • Multi - position length stop
Optional equipment & accessories
  • Dead center ( MT4 ) 2 PC
  • Center sleeve MT6 x MT4
  • 7" backplate
  • Steady rest
  • Follow rest
  • Face plate ( 350 mm )
  • Turret micro carriage stop
  • Taper turning attachment
  • 3 - jaw chuck
  • 4 - jaw chuck
  • Work light
  • Rear toolpost
  • Main motor 7.5HP / 4P
  • Full length splash guard
  • Drill attachment
HEADSTOCK

Gear in the headsotck are treated by cementation and precisely ground. Forced lubrication system is employed. HP Model with P5 grade spindle bearing is optional.


GEAR BOX

It offers a comprehensive range of inch and metric threads without the use of change gears. All gears in the gear box are hardened.


APRON

Apron is equipped with a manual and automatic lubrication system. It will keep cross slide ways and bedways clean and lubricated. The apron is equipped with an overload protection device to avoid machine damage.



YOU MIGHT ALSO LIKE

Contact us

+ 886 4 2566 6113

+ 886 4 2566 3114

ufkinwa@ms15.hinet.net

No. 10 Tien Shin Street
Ta Ya Taichung 42865 Taiwan